BK Precision 4084AWG Manuel d'instructions télécharger pdf (Page 40)

onlinecomponents.com

4080 series Function & Arbitrary/Function Generators –Instruction Manual

PULSe:DCYCle?

Check the duty cycle of current pulse output. The returned value is percentage.

VOLTage <amplitude>

Set the amplitude of the currently active waveform. The amplitude setting should be consistent with

the technical specifications. The output amplitude ranges of P_PULSE, N_PULSE, P_DC and

N_DC should be 2mVpp ≤ ampl ≤ 10Vpp in high impedance output setting and 1mVpp ≤ ampl ≤

5Vpp in 50Ω setting. The above value is given based on a DC offset of 0V. If a DC offset is used,

refer to the setting of DC offset described in Chapter 4 in this manual

VOLTage？

Check the output amplitude of current main function output.

VOLTage OFFSet <offset>

Set the DC offset. For the relationship between the DC offset and output amplitude, refer to section

4.5.3.

VOLTage OFFSet？

Check the DC offset of main function output.

OUTPut:LOAD {50|INFinity}

Configure the amplitude display value for 50Ω or high impedance (INFinity) load termination. The

output amplitude should be consistent with the technical specifications.

OUTPut:LOAD？

Read the current load impedance setting of the function generator.

INPUT: FILTER {ON|OFF}

Enable/disable the low pass filter for the counter

INPUT:FILTER?

Read the current “on/off” state of the low pass filter.

INPUT:ATTenuator {ON|OFF}

Enable/disable Set the input attenuator of the counter

INPUT:ATTenuator?

Read the state of the input attenuator (on/off)

*SAV {0|1|2|3|4|5|6|7|8|9|10}

Save as many as 11 input states of the instrument. Among the 11 states, state 0 is used to

automatically store the power off setting of the instrument. States 1~10 are user defined.

*RCL {0|1|2|3|4|5|6|7|8|9|10}

Recall one of the states 0 -10.

RF:STATe <ON/OFF>

Enables/Disables main output

RF:STATe?

Reads the current state of the main output

AM instructions

1．To set the carrier of output using APPLy instructions or FUNCtion, FREQuency, VOLTage,

VOLTAGE: OFFSet instructions.

2．To set modulating waveform of AM using AM:INTernal: FUNCtion

{SINusoid|SQUare|TRIangle……} instructions

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 60 61

Commentaires sur ces manuels

Pas de commentaire

BK Precision 4084AWG Manuel d'instructions Page 40

Commentaires sur ces manuels

Produits connexes et manuels pour Générateurs d'électricité BK Precision 4084AWG